







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Kohler Home Additions & ADU: The Boulder City Owner’s Guide
Owners in Boulder City who want a Kohler-fixture guest suite, casita, or detached ADU typically budget $45,000 – $130,000 for a home addition and $90,000 – $220,000 for a ground-up ADU. We build these as an independent contractor and source Kohler fixtures through the same documented supply chain we use on every project, with a written price before any work starts.
The failure pattern we see isn’t a cracked Kohler part. It’s a Kohler fixture installed in an addition that was framed too tight, vented wrong, or wired to a circuit that was never sized for the load. You find out months later: a slow drain in the new bathroom, a Kohler shower valve that runs cold when the kitchen sink kicks on, or a toilet that rocks because the subfloor under it never got stiffened. The fixture gets blamed. The framing and rough-in are usually the real story.
- Written price before work starts – always, no exceptions.
- 365-Day Done Right Promise on every completed project.
- Background-checked, uniformed technicians on every job.
- Live person answers the phone, 24/7 – not voicemail.
Which Kohler Models This Applies To

Kohler’s plumbing line is where most Boulder City additions get specific. The Kohler Memoirs and Kohler Devonshire toilet lines use different tank-to-bowl bolt patterns than the Kohler Wellworth, and the rough-in dimension (10-inch, 12-inch, or 14-inch from finished wall to drain center) has to match the floor cut before tile goes down. Get that wrong and you’re cutting concrete or building a false wall – a $600 mistake that turns into a $2,400 one.
For showers, Kohler’s Rite-Temp pressure-balancing valves and Kohler DTV+ digital systems are not interchangeable. DTV+ needs a dedicated power supply at the valve location; if your electrician didn’t rough one in, the wall opens back up. Identify what you have before ordering anything: read the model tag inside the toilet tank lid, the valve trim ring, or the sink’s underside stamp. That number, not the showroom photo, is what the part gets matched to.
On the OEM-versus-aftermarket question for Kohler specifically: genuine Kohler cartridges and valve bodies carry Kohler’s own warranty, and aftermarket equivalents can void it. On finish trim and accessories, quality equivalents are usually fine. On anything behind a wall, we specify OEM. That’s a durability call, not a brand loyalty one.
Our technicians have up to 22 years of experience reading these spec sheets and catching mismatches before the drywall closes. We also work with KraftMaid, Cambria, and Silestone on the cabinetry and surface side of additions, so the fixture-to-finish coordination is documented in one scope instead of split across three trades.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Kohler Home Additions & ADU Is Failing
- The new bathroom drains slowly after a few months. Usually a venting problem in the addition’s plumbing stack, not a Kohler trap issue. An addition tied into the main house vent without its own air path pulls water out of traps and drains sluggishly.
- Kohler shower valve runs cold when another fixture turns on. Pressure-balancing valves compensate for pressure drops, but they can’t fix undersized supply lines. A 1/2-inch line feeding both the new bath and the kitchen is the culprit most of the time.
- The toilet rocks or the base seal leaks. The subfloor under the flange wasn’t stiffened for the added load, or the flange sits below finished tile height. Kohler toilets are heavy; a soft floor shows it fast.
- Condensation on the ADU’s interior walls in summer. Boulder City’s desert swings – hot days, cool nights – punish additions that were insulated without a proper vapor strategy. Kohler fixtures aren’t the cause, but the moisture shows up around them first.
- GFCI trips at the new bathroom outlet. A dedicated circuit wasn’t run for the addition’s bathroom. Kohler’s DTV+ and heated bidet seats draw more than a shared circuit wants to carry.
Replacement Cost & What’s Included

Every price below is a written range for Boulder City work, parts and labor included, and it’s the number you see before we start – not a number that moves at the door.
| Scope | Written Price Range |
|---|---|
| Home Addition (room, suite, or bump-out) | $45,000 – $130,000 |
| ADU Construction (detached, ground-up) | $90,000 – $220,000 |
| Garage Conversion (to living space) | $30,000 – $80,000 |
What drives the range: foundation and slab work, whether the addition ties into existing utilities or needs new service, roof pitch and tie-in complexity, and the fixture spec. A Kohler Memoirs suite with a DTV+ shower lands at the top; a standard Rite-Temp setup with Wellworth toilets lands lower. The written quote breaks out fixtures, rough-in, finishes, and labor so you can see what’s driving the number. Every completed project carries the 365-Day Done Right Promise: if the work fails within a full year, we return and correct it at no charge.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
Here’s the honest split. You can safely check model numbers, confirm rough-in measurements, photograph the existing plumbing and electrical, and read your HOA or city paperwork. Planning and paperwork are fair game for a homeowner.
The electrical panel work, gas line runs, and structural framing on an addition or ADU are not. Boulder City sits in a high-wind and seismic-design region, and the attachment details that keep a new roof and egress path safe are not guessable from a video. Electrical panel and sub-panel work is the other hard stop – a miswired panel is a fire and shock hazard, full stop. That’s a trained, permitted job. We pull permits and pass inspections as standard; doing it without either is what turns a $90,000 ADU into a $140,000 problem at resale.
Kohler fixture swaps behind a wall fall in the same category. Call us at (844) 797-9259 and we’ll schedule your free estimate – we answer live, 24/7.
FAQs

The build itself should hold for decades if it’s done right, but the Kohler rough-in behind the wall is where failures show up first – typically 3 to 7 years in if the venting or circuit sizing was off from day one. The fixture outlasts the mistake, which is why we document the rough-in on every job.
Often yes. A Kohler cartridge can be rebuilt, a leaking valve body can sometimes be serviced, and a slow drain is usually a venting fix, not a fixture replacement. We diagnose before we quote. If a repair holds, we tell you – the 365-Day Done Right Promise covers the correction either way.
A single fixture swap takes an afternoon; an addition with full Kohler rough-in runs 8 to 16 weeks depending on foundation and utility tie-ins, and an ADU runs 4 to 8 months. We give you the schedule in writing before we start and update you on any change before it happens, not after.
We source through Kohler’s documented supply chain – OEM parts for anything behind a wall, and quality equivalents on visible trim where Kohler’s warranty isn’t affected. Bradford Remodeling Boulder City is an independent contractor and not affiliated with Kohler, so we specify what the spec sheet calls for, not what a showroom wants to move. Call (844) 797-9259 for an exact quote – estimates are free.
Get Your Free Boulder City Estimate
If you’ve got a Kohler fixture you love and an addition or ADU to put it in – or a new extra room already framed and half-finished – we’ll give you a written price before any work starts, the scope broken out line by line, and the 365-Day Done Right Promise in writing. Call Bradford Remodeling Boulder City at (844) 797-9259 for a free estimate. A live person answers, day or night.
Written by the team at Bradford Remodeling Boulder City, serving Boulder City and nearby areas.












