







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Blanco Home Additions & ADU: The Boulder City Owner’s Guide
If you’re adding space to a Boulder City home that already carries Blanco fixtures, we install and finish additions and ADUs to work around that plumbing footprint instead of ripping it out. Home additions here run $45,000 – $130,000, and a detached or attached ADU runs $90,000 – $220,000. This is planned construction, not emergency work, so we schedule a free estimate first and give you a written price before any tool comes out.
Owners usually arrive at this page the same way. A Blanco fixture or rough-in tied to an older addition starts leaking, backing up, or fitting sloppily against a wall that was never squared, and the first contractor shrugs and says the fixture is the problem. It’s rarely the fixture. It’s the connection, the framing, or a dimension that was guessed at. We’re an independent contractor, not affiliated with Blanco, and that lets us tell you honestly whether the fixture stays or goes.
Which Blanco Models This Applies To

Blanco’s reach into a Boulder City addition is mostly kitchen and utility: SILGRANIT sinks in the DIAMOND, PRECIS, and IKON lines, the QUATRUS and CERANA stainless models, and the brand’s faucets and soap dispensers. When we scope an addition, we identify what’s actually there before we draw anything. That means reading the label or stamp under the sink rim or on the faucet body, measuring the cutout in the counter (length, width, corner radius), and noting the mounting style (undermount, drop-in, or farmhouse apron front). Those three facts decide whether the fixture carries into the new room or gets replaced.
Here’s the compatibility gotcha most people miss: SILGRANIT sinks have a heavier composite body and a specific cutout radius that a generic granite fabricator won’t match off the shelf. If the new counter is Cambria or Caesarstone quartz, the cutout has to be templated to the exact Blanco model number, not to the old sink’s measurement. Apron-front IKON models also require a cabinet with a shortened front rail, which changes base-cabinet layout in the addition. Get that wrong and you’re reordering cabinets.
On OEM versus aftermarket: for a sink or faucet, the Blanco OEM part is usually the right call because the warranty and the fit are tied to the model number. For mounting hardware and drains, a quality aftermarket equivalent from a known brand is fine if it matches the spec. We work from a documented roster of name-brand materials (Blanco among them, plus KraftMaid, Cambria, and Silestone), so every spec is traceable on paper.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Blanco Home Additions & ADU Is Failing
- Water staining at the base of a wall in the addition. Usually a rough-in connection that was never properly sealed where the new plumbing meets the old. Both sides have to be pressure-tested, not one.
- The Blanco sink rocks or the sealant keeps failing. The cutout was oversized or the undermount clips weren’t set to the composite rim. SILGRANIT is rigid and unforgiving of a sloppy template.
- Doors and windows in the addition stick seasonally. That’s framing movement, common in Boulder City’s swing between dry desert heat and cool nights. It points to lumber that wasn’t acclimated or a header that’s undersized.
- The new floor feels hollow or springs near a threshold. Substrate wasn’t leveled or fastened correctly where the addition ties into the original house. This one gets worse, never better, if ignored.
- Drafts or heat at the seam between old and new walls. The tie-in flashing and insulation were rushed. In our climate that shows up as high summer cooling bills before it shows up as a visible gap.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

For this page’s scope, the installed ranges are below. These are written prices, not estimates that move when the crew shows up.
| Home Addition | $45,000 – $130,000 |
| ADU Construction | $90,000 – $220,000 |
| Garage Conversion | $30,000 – $80,000 |
The range moves with square footage, foundation type (slab is simpler than a raised floor), whether plumbing is relocated, and how much of the existing Blanco and cabinet layout carries over. What’s included in our written price: permits pulled and inspections passed, demo and haul-off, framing, rough-in, finish work, and a clean site at close. Every completed addition carries the 365-Day Done Right Promise. If the work fails within that year, we come back and correct it at no charge.
DIY or Call Us?
An owner can safely check a few things: confirm the Blanco model number on the label, photograph the cutout and connections, and note where water or movement is showing up. That saves time on the estimate. Where DIY goes wrong is structural. Framing a tie-in, moving a rough-in, or re-templating a counter for a heavy SILGRANIT sink is not a weekend job, and an undersized header or a bad flashing job is a safety issue, not a cosmetic one. It’s the kind of mistake that shows up two winters later. Our technicians have up to 22 years of experience and are background-checked and uniformed, so you know who’s walking through the door. Call (844) 797-9259 and we’ll schedule your free estimate and put the price in writing before anything starts.
FAQs

A properly built addition should hold its plumbing and framing well past a decade; failures we see usually show up in the first two years and trace back to the rough-in or the tie-in, not the fixture. If yours is already failing inside that window, the original work was likely rushed. Call (844) 797-9259 and we’ll look at what can be corrected.
Often yes. A leaking rough-in or a rocking sink can usually be reset or resealed without tearing out the room. Structural framing problems are a different matter and need a real look. Call (844) 797-9259 for an honest answer on repair versus rebuild.
A home addition typically runs several weeks to a few months depending on size and inspections; an ADU runs longer because of the separate permit and utility work. We give you a schedule in writing with the price. Call (844) 797-9259 to get your timeline.
We match to the exact Blanco model number first, then source OEM where fit and warranty depend on it, and quality aftermarket equivalents for drains and hardware where the spec allows. Everything is documented on the quote. Call (844) 797-9259 to start with a free estimate.
Written by the team at Bradford Remodeling Boulder City, serving Boulder City and nearby areas.












