







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Ameristar Fence Installation: The Boulder City Owner’s Guide
Ameristar aluminum fence installation in Boulder City runs $3,500 – $9,000 installed for most residential runs, and our technicians have up to 22 years of experience installing Ameristar-compatible panels, posts, and gates. Nearly every call we take on a failing Ameristar run traces back to one of three things: a loose post footing in caliche, a gate hinge pin sheared off its weld, or powder coat chewed through by sun. Boulder City homeowners usually spot it the morning after a wind event, when a gate drags on the concrete or a section leans a degree or two off plumb.
Key takeaways
- Installed Ameristar fence pricing in Boulder City: $3,500 – $9,000 for a typical residential run.
- UV and wind are the two failure drivers here, not rust.
- Written price before work starts, covered by the 365-Day Done Right Promise.
- Bradford Remodeling Boulder City is an independent service provider and is not affiliated with Ameristar.
Which Ameristar Models This Applies To

Ameristar builds several residential aluminum lines, and the parts do not swap across them. The common ones you’ll see on Boulder City properties are the Montage series (panelized, rackable sections), the Liberty and Liberty Plus lines (heavier rails, welded panels), and the Bayview and Wakefield ornamental designs for front-yard runs. Before we quote anything, we want the model name off the original spec sheet or the label on the inside of the gate frame. If that’s gone, we measure: post spacing, rail height, picket spacing, and the hinge bolt pattern, because two Ameristar lines that look identical from twenty feet use different hinge hardware.
The OEM-versus-aftermarket call depends on the part. For pickets and rails, an aftermarket piece matched to the same series is usually indistinguishable and costs less. For structural castings like post caps, gate corners, and hinge assemblies, we use Ameristar-spec hardware because aftermarket castings are where we see early failures in Boulder City’s heat cycling. Either way, we write the exact part, the series it fits, and the price on the estimate before anyone touches a tool.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Ameristar Fence Installation Is Failing
An Ameristar run rarely fails all at once. It fails at one point and telegraphs the rest.
- A gate that drags on the slab. Usually a worn or sheared hinge pin, or a hinge post that has lost its footing. The gate itself is fine; the hardware or the post is not.
- Posts leaning after wind. Boulder City sits on caliche that doesn’t drain, and a post hole that wasn’t set deep enough or wasn’t backfilled properly will walk. Once one post moves, the adjacent sections carry load they weren’t sized for.
- Powder coat chalking or flaking. Southern Nevada UV is unforgiving. Finish breakdown at the welds and rail tops points to a coating near the end of its life, which means corrosion starts next.
- Rattling or loose pickets. Loose picket-to-rail fasteners, often from thermal expansion that worked a fitting loose over a few summers. Easy to catch early, expensive if ignored.
- A gate that won’t latch square. A sagging gate or a shifted post. Left alone, the latch strikes the gate frame, and the frame eventually cracks at the weld.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

For a full Ameristar fence installation or a substantial gate and section replacement in Boulder City, plan on $3,500 – $9,000. The range is driven by three things: linear footage, terrain (caliche slows every post hole), and gate hardware. A single gate with Ameristar-spec hinges and latch sits at the low end. A long run with ornamental panels and two gates sits at the top. We also handle interior work – KraftMaid, Cambria, and Silestone among our documented brands – so if the fence job turns into a whole-exterior conversation, one written scope covers it.
Your estimate shows parts and labor as separate lines. No number moves once work starts. Every completed job carries the 365-Day Done Right Promise: if the install fails within a year, we come back and correct it at no charge.
DIY or Call Us?
You can safely walk the line and check for wiggle. Push each post at the top; if it moves more than a quarter inch, it’s a footing problem, not a hardware problem, and that’s not a DIY fix. Replacing pickets, tightening picket fasteners, or swapping a hinge pin on a lightweight residential gate is within reach for a careful homeowner with the right socket set. Resetting a post in caliche, or replacing a gate frame weld, is where we see DIY jobs come back to us. Under-set posts move again within a season, and a gate rehung out of plumb stresses every hinge on the run.
If you’re not sure which side of that line your repair sits on, call (844) 797-9259. A live person answers 24/7, and we’ll tell you straight whether it’s a ten-minute check or a crew job.
FAQs

A properly installed Ameristar aluminum fence holds up 20 years or more, but the finish and footings are the limiting factors in our climate rather than the metal. Southern Nevada UV breaks down powder coat over 8 to 12 years, and caliche soil punishes shallow post holes. Good setup and the occasional post check get you the full life.
Usually yes, especially if one gate, one section, or the hardware is the failure point. We match the replacement part to your Ameristar series so the repair blends in. Call (844) 797-9259 for a written quote on the repair before we quote a full replacement.
Most single-gate or single-section replacements finish in a few hours. A full run takes one to two days, and dig time in Boulder City caliche is the main variable. We give you the timeline with the written price, before a tool comes out.
We identify your Ameristar series from the label, the spec sheet, or measured dimensions, then order the matching OEM or an equivalent aftermarket part. We don’t claim stock on a truck or inventory at a local yard. The exact part number and price go on the estimate in writing.
Free estimates by phone: call (844) 797-9259. Our technicians are background-checked, uniformed, and covered by The Garrison Standard, and the finished job closes with a clean site and a signed written guarantee in your hand.
Written by the team at Bradford Remodeling Boulder City, serving Boulder City and nearby areas.












