







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Ameristar Home Additions & ADU: The Boulder City Owner’s Guide
Ameristar-compatible additions and ADUs are build-to-spec projects, not off-the-shelf parts. In Boulder City, a full home addition runs $45,000 – $130,000 installed, and a detached or attached ADU runs $90,000 – $220,000. There’s no same-day swap here: site work, permits, rough-in, and finish carpentry each take real time, and we give you a written price before anything starts. Most owners call us after a failed inspection, a contractor walk-off, or a structural issue that turned up mid-build. If you’re holding a half-finished addition or a plan set that stalled, that’s exactly the job we’re built for.
Which Ameristar Models This Applies To

Ameristar covers several product lines under its home additions and ADU umbrella, from panelized room additions to modular and detached ADU packages. Each line carries its own spec sheet, fastener schedule, and header sizing. The label matters: check inside the panel edge, on the frame stamp, or in the plan set Ameristar provided with the original order. The model designation usually tells you the series, span, and load rating. Get that number wrong and you’re ordering a header or panel that won’t pass Clark County review, which costs far more than the part.
Here’s where we see real problems in Boulder City: Ameristar ships panelized components with hardware spec’d for a specific framing system, and mixing lines mid-project is common. An owner will have Ameristar panels from one series and Ameristar fasteners or connectors from another, and they don’t always mate cleanly. The fix is measurement, not guesswork. Measure the panel width, the rough opening, and the connector type before you order anything. On the OEM-vs-aftermarket question: Ameristar factory panels and connectors are worth the price premium when they’re the part that carries the load. Aftermarket equivalents are fine for trim, flashing, and finishes. We don’t carry parts and we don’t keep a warehouse; we order to spec per job so the material matches what’s already on your structure.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Ameristar Home Additions & ADU Is Failing
Ameristar components are engineered, not hand-built, so failures tend to show up in predictable places. Here’s what to look for:
- Racking or out-of-plumb walls. When a panelized addition starts to lean, it’s usually a connector that wasn’t torqued to spec or a footing that settled in Boulder City’s caliche-heavy soil. The wall moves because the anchor lost grip.
- Roof-to-wall separation at the tie-in. A visible gap or daylight line where the addition meets the existing house points to flashing failure or a header that’s sagging under load. Catching this early avoids water intrusion that rots the substrate.
- Door and window binding. If frames stick or gaps open unevenly, the rough opening has shifted. Ameristar units are squared precisely at the factory; if they’re binding in place, the structure around them moved.
- Moisture staining or mold at panel seams. Ameristar seam tape and weather barrier need to overlap a specific way. When seams fail, desert monsoon moisture finds them and the panel edge takes on water.
- Failed connectors or uplift hardware. Rusted, loose, or missing hurricane-rated ties where the addition ties to the original structure. In Clark County, uplift hardware gets inspected for a reason, and a missing tie is a real finding.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Home addition installed pricing in Boulder City runs $45,000 – $130,000. ADU construction runs $90,000 – $220,000. Garage conversions run $30,000 – $80,000.
| Scope | Typical Installed Range |
|---|---|
| Home Addition | $45,000 – $130,000 |
| ADU Construction | $90,000 – $220,000 |
| Garage Conversion | $30,000 – $80,000 |
What moves the range: square footage, foundation type, whether the addition needs its own utility runs or can tie into existing service, and how much of the Ameristar panel or component set has to be replaced versus kept. A structural repair to an existing addition lands toward the lower end; a full ADU is its own project.
Every number we give is a written price before work begins, itemized by parts and labor. No surprises at the door. Completed work carries the 365-Day Done Right Promise: if the addition fails inside that year, we come back and correct it at no charge. We pull the permits and we pass the inspections; that’s part of the scope, not an extra.
DIY or Call Us?
Some checks are safe for a homeowner. You can walk the perimeter, look for daylight at the tie-in, look for rust on connectors, and check that doors and windows aren’t binding. What you shouldn’t do is re-torque structural connectors, sister a sagging header, or re-flash a roof-to-wall joint on an addition that carries load. Structural work is where DIY goes wrong and where an honest inspector catches it later. The failure mode isn’t just an expensive redo; it’s a wall that moves when it shouldn’t. If you’re seeing racking, roof separation, or binding units, stop and call (844) 797-9259 for a free estimate. We’ll tell you what’s actually failing and what it costs to fix it right.
FAQs

How long should an Ameristar addition last in Boulder City? A correctly installed Ameristar addition should last decades, well beyond 30 years, because the panels and connectors are engineered components. Lifespan comes down to installation quality and the foundation. Caliche soil in Boulder City and desert temperature swings are hard on footings, and a footing that settles early is the most common reason an addition doesn’t make it to that number.
Can you repair the addition instead of replacing the whole thing? Yes, if the problem is isolated. Connector replacement, flashing repair, and header work are common and cost far less than a rebuild. A full replacement is only the answer when multiple panels are compromised or the footing has failed. We assess first, then give you a written price for the repair scope. Call (844) 797-9259 to schedule the estimate.
How long does an Ameristar addition or ADU take? A small addition takes weeks, not days; a full ADU takes months, and Boulder City permit review adds time to both. Anyone quoting a same-day or same-week install on structural work isn’t being straight with you. We give you a written schedule with the price so you know what to expect.
How do you source Ameristar components? We identify your Ameristar model and series from the label or plan set, then order the factory-spec panel, connector, or flashing to match. We don’t carry parts and we don’t keep inventory, so you’re not getting a generic part swapped onto a system it wasn’t built for. We also work with KraftMaid, Cambria, and Silestone on the finish side. Call (844) 797-9259 for a free estimate.
Bradford Remodeling Boulder City is an independently owned and operated member of the Garrison Partners family, held to The Garrison Standard, and we’re not affiliated with Ameristar. Every project is covered by a written price up front and the 365-Day Done Right Promise after close. Our technicians have up to 22 years of experience. Call (844) 797-9259 to schedule your free estimate for your Ameristar addition or ADU in Boulder City.
Written by the team at Bradford Remodeling Boulder City, serving Boulder City and nearby areas.












