







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
ES Windows Roofing: The Boulder City Owner’s Guide
ES Windows roofing components on a Boulder City home are generally installed by us as a shingle-to-flashing assembly, with roof repair running $400 – $1,800 and full roof replacement at $8,000 – $20,000 depending on pitch, square footage, and how the existing deck integrates with your window head and sill. Most Boulder City owners find out something has failed after a ceiling stain appears below a window head, or after a wind-driven rain event pushes water past the head flashing and into the wall cavity.
The pattern is consistent: ES Windows units themselves hold up fine, but the roofing and flashing interface around them is where the water gets in. Desert sun bakes the sealant, the next monsoon pushes hard from the southwest, and the gap you never saw on a dry day shows up as a brown ring on the drywall.
Which ES Windows Models This Applies To

The roofing components that pair with ES Windows units are not tied to a single model line – ES Windows has produced aluminum, vinyl, and impact-rated series over the years, and each series uses a different nailing fin depth and head flange profile. That matters because the flashing detail on top of the window depends on the flange geometry, not the glass. If the flange on your unit is 1-3/8 inch deep versus 1-1/2 inch, the head flashing cassette that sits over it needs to match or you get a lip that collects water.
To identify what you have, look at three things in order:
- The interior label – most ES Windows units carry a sticker with the series code and manufacture date inside the jamb or on the head. Photograph it before anything else.
- Visible glass etching – impact-rated lines are marked in the corner with the impact standard code and the manufacturer mark.
- Measured flange depth – a tape measure against the nailing fin, perpendicular to the frame, gives you the number you need to source a matching flashing profile.
For the OEM-versus-aftermarket decision: on an ES Windows unit, the OEM head flashing and sill pan match the profile exactly, which matters in Boulder City where wind-driven rain hits at an angle rather than straight down. Aftermarket flashing from a roofing supplier can work, but the installer has to bend and cut it to match the flange, and a poorly fitted aftermarket piece is the single most common cause of repeat leaks we see on these installs. Bradford Remodeling Boulder City is an independent service provider and is not affiliated with ES Windows.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your ES Windows Roofing Is Failing
- Water staining on the ceiling or header directly below a window. That is head flashing failure – the metal that sheds water over the top of the window has lifted or failed at the sealant joint, and the water is running down the wall cavity instead of off the roof.
- Peeling paint or soft drywall at the window head, inside. The substrate has absorbed moisture from a slow leak that runs behind the paint film. It usually starts small and gets worse over two or three monsoon seasons before it’s obvious.
- Granule loss on the shingles above and beside the window frame. Sun-facing slopes in Boulder City lose granules faster than shaded slopes, and field shingles and flashing do not age at the same rate. Shingles that are still dark and fresh next to a rusted flashing piece tell you the flashing is the weak point.
- Visible rust or lifting at the flashing edge on the roof. The metal has corroded or the sealant under it has cracked under UV exposure – this is the most common failure in Nevada, where a roof can see 300-plus days of sun per year and sealants dry out within three to five years.
- Drafts or daylight at the window perimeter on a windy day. An air leak at the head is a water leak in waiting. The flashing is no longer seated against the flange, which means water has a path once it gets pushed sideways.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Boulder City roofing repair around ES Windows units runs $400 – $1,800. Full roof replacement with proper window flashing at every penetration runs $8,000 – $20,000. If the failure is scoped to tile roofing, tile roof repair runs $600 – $2,500. Impact window installation, when the window itself must come out to redo the flashing correctly, runs $8,000 – $25,000 for a full set.
The range is driven by roof pitch and access first, then by how many penetrations need reflashed, then by material: a simple asphalt shingle repair around two windows is on the low end, a tile or metal roof that has to be picked up and re-laid around the flashing is on the high end. What’s included in the price we write before any work starts: removal of the failed flashing, inspection of the substrate and sheathing, replacement of any rotted decking found under the flashing (priced line-item if it’s more than a small area), new flashing matched to your ES Windows flange profile, sealant, and the surrounding shingles or tiles. Every completed project is covered by our 365-Day Done Right Promise – a full written year, and if the work doesn’t hold inside that window we come back and correct it at no charge.
DIY or Call Us?
You can safely check a few things yourself: look for interior staining, photograph the ES Windows label, and from the ground with binoculars, note any rusted or lifted metal at the roof edge over the window. Those observations are useful and cost nothing.
What we don’t recommend is climbing a ladder onto a pitched roof to reseal the flashing. Boulder City roofs run hot by mid-morning, the shingle surface is soft, and a slip on an asphalt or tile roof from 12 feet up is not worth saving a few hundred dollars. Working under a tile field or lifting a metal panel by hand also risks cracking the tile or bending the panel – and worse, a resealed flashing that looks fine does not always fix the underlying water path, so the leak comes back behind the new sealant and you lose a season before you notice.
The honest version: DIY gets you the diagnosis, not the repair. When you’re ready to hand it to a crew, call (844) 797-9259 for a free estimate and a written price before anything moves.
Frequently Asked Questions

Head flashing and sealant around an ES Windows unit typically fail somewhere between five and ten years in Boulder City, with sealant joints the first thing to go – usually in three to five years of full sun exposure. The shingles themselves last longer, which is why the flashing is the item to inspect on an annual basis rather than a one-time decision.
Yes, often. Most ES Windows-related roof leaks we scope in Boulder City are fixable with targeted flashing replacement and re-sealing at the window head, which lands in the $400 – $1,800 repair range. Full replacement only makes sense when the surrounding shingles are at the end of life, or the sheathing has rotted beyond a small area. Call (844) 797-9259 and we’ll tell you which one it is, in writing.
A single-window flashing repair typically finishes in a few hours; multiple window penetrations or a roof replacement are scheduled over consecutive days rather than one long day. The written scope you get before work starts includes the days, not a vague “sometime this week” – that is the Garrison Standard at work.
We source flashing matched to the measured flange depth on your ES Windows unit and coordinate with the roofing manufacturer of record for the shingle or tile already on your roof. Where an original ES Windows part is no longer available, we specify a compatible substitute that meets the same profile and thickness, and we show you both options and prices before any work begins. Specs are documented, not guesswork.
If your ES Windows roofing is on your list this year, call Bradford Remodeling Boulder City at (844) 797-9259 for a free estimate. We’ll put the price in writing before a single tool comes out, and every completed job carries the 365-Day Done Right Promise. We also work with KraftMaid, Cambria, and Silestone on the interior side, so a roof repair and a window trim refresh can be squared away on one schedule if you want it that way.
Written by the team at Bradford Remodeling Boulder City, serving Boulder City and nearby areas.












