A Bradford company - serving Boulder City, NV
A remodeled kitchen with a wood island, painted cabinets and a plaster range hood
Schluter · Boulder City

Schluter Kitchen Remodeling in Boulder City, NV

Free Estimate on SiteCalls Answered by a Live Person, 24/7Background-Checked TechniciansA Local Team in Boulder City
A walk-in pantry with wood shelving
A remodeled kitchen with a waterfall island and wood cabinets
An open kitchen and dining area after a remodel
A galley kitchen opened up to the dining room with a new peninsula
A stone counter, tile backsplash and open shelf after a kitchen remodel
A remodeled living room with built-in shelves around the fireplace
A single-story rear room addition with tall windows and a new patio
A freestanding soaking tub in a remodeled primary bathroom
Every visit starts with

Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled

We have financing partners for your dream remodel*On approved credit; ask us about your options
Get your free estimate

Schluter Kitchen Remodeling: The Boulder City Owner’s Guide

We install Schluter-based kitchen remodeling in Boulder City, using the Kerdi, Ditra, and Kerdi-Board systems to build waterproof, uncoupling assemblies under tile, showers, and backsplashes. Typical installed kitchen remodeling in Boulder City runs $14,000 to $45,000, and if your Schluter part has already failed, we can price a targeted repair as part of that range. Bradford Remodeling Boulder City is an independent contractor, not affiliated with Schluter.

Call (844) 797-9259

Owners usually find a failing Schluter part the same way. Grout starts cracking along a shower bench or backsplash seam. A tile sounds hollow when you tap it. Or you pull up a corner of the shower floor and find soft, dark mud where the waterproofing membrane should be. That dark mud is the first sign a Kerdi or Ditra layer has failed, and in Boulder City’s climate the cause is almost always tied to heat and the dry swing between seasons.

Key Takeaways:

  • Kitchen remodeling in Boulder City: $14,000 – $45,000 installed, Schluter waterproofing included.
  • Kerdi, Ditra, and Kerdi-Board parts are matched by series and roll or sheet dimension.
  • Hollow tile or cracked grout on a shower floor points to a failed membrane bond.
  • A written price lands before work starts. Every finish carries the 365-Day Done Right Promise.

Which Schluter Models This Applies To

Installers leveling a new base cabinet during a kitchen remodel

Schluter’s kitchen and wet-area parts fall into a few families, and matching the right one matters more than most homeowners expect. The Kerdi membrane line comes in rolls measured by width and length (roughly 39-inch and 1-meter widths are the common ones), and Kerdi-Board panels come in set thicknesses (1/2-inch and 2-inch show up most often in shower and backsplash work). Ditra, the uncoupling mat under floor tile, ships in rolls by width, and Ditra-Heat adds a cable grid with its own thermostat connection.

To identify the right part, read the printed label on the roll core or the panel edge. Schluter stamps the series name, dimensions, and batch code there, and that stamp is what you match against. A photo of the label tells us exactly which version you have.

The OEM-versus-aftermarket decision breaks down cleanly for Schluter. There is no true aftermarket equivalent for Kerdi or Ditra. The orange membrane is bonded fleece on both faces, and the waterproofing guarantee depends on that specific fleece fusing to thinset. Generic uncoupling mats and blue or gray sheet membranes don’t carry the same tested bond, so we install genuine Schluter parts on anything we warranty. Where a part is a simple accessory (a Kerdi-Fix sealant tube, a drain grate, a trowel), aftermarket is fine and we’ll say so.

One compatibility gotcha worth flagging: Kerdi-Board and standard drywall cut the same, look similar when stacked, and get mixed up on a job site. A homeowner who buys the wrong panel gets a board that won’t hold a tile edge in a wet zone. Check the panel legend before you buy.

Explore

Styles & brands we work with

  • Kitchen remodeling
  • Bathroom remodeling
  • Home additions & ADU
  • Roofing
  • Windows & doors
  • Driveway & pavers
  • Fence

Signs Your Schluter Kitchen Remodeling Is Failing

  • Hollow-sounding tile over a shower floor or bench. This means the thinset never fully bonded to the Kerdi fleece, or the membrane lifted. Tap with a screwdriver handle and listen for the dead thud.
  • Cracked grout along a backsplash or counter seam. That line is the movement joint, and if the Ditra or Kerdi layer was omitted or bridged, seasonal expansion splits the grout first. In a Boulder City kitchen with west-facing glass, the daily heat swing does this faster than most owners expect.
  • Water staining or a musty smell near the shower curb. A failed Kerdi band at a corner lets water behind the tile. The stain appears weeks before the soft spot does.
  • Soft or dark thinset visible after removing a tile. This is the advanced stage. Water reached the substrate, and the membrane is no longer doing its job.
  • Loose floor tile over a kitchen entry. A Ditra mat that lost its bond allows tile to rock, and once one tile rocks, the joint system has failed around it.

Two of these are quick checks. The hollow-tile tap and the grout-crack inspection take five minutes and tell us a lot. The others usually mean pulling a tile to confirm, and we price that as part of a repair.

Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

A remodeled family room with new windows and a window seat

For Boulder City, a kitchen remodel with new Schluter wet-area waterproofing installed runs $14,000 to $45,000. A smaller kitchen remodel lands in the $9,000 to $20,000 range. If you’re only replacing a failed segment (a shower bench, a backsplash run, a floor area), the repair is priced inside that band once we see how far the failure spread.

What drives the range: square footage, whether we’re rebuilding the substrate under the failed membrane, the tile and stone you choose, and whether the job is a straight replacement or a full remodel. The parts alone are a small slice. Labor and substrate prep are the bulk, and prep is where Schluter work lives or dies. A membrane installed over a wet or dirty substrate will fail again, so we never skip that step.

You get a written price before any work starts, with line items for parts, labor, and prep. There’s no repricing at the door. Every completed project carries the 365-Day Done Right Promise; if the Schluter installation fails inside that window, we come back and correct it at no charge. Our technicians have up to 22 years of experience. We also install KraftMaid, Cambria, and Silestone finishes for the kitchen pieces around the tile work.

DIY or Call Us?

Some of this is safe to check yourself. Tapping for hollow tile is fine. Inspecting grout cracks and looking for water staining is fine. Photographing the label on your Schluter roll or panel is fine, and it helps us match the part.

What an owner should not attempt is pulling a membrane off a wet substrate and re-tiling blind. Kerdi and Ditra failures are rarely the membrane’s fault; the bond underneath failed because of moisture, dust, or a wrong thinset. Re-tiling over the same failed layer hides water behind the tile for another season. That’s a job for a crew that can prep the substrate and set the membrane to Schluter spec. There’s a genuine risk of trapping water and rot, and the finished tile can’t be inspected once it’s down.

Call (844) 797-9259 if you’re ready for a straight number. We’ll look at the part, tell you what failed, and give you a written price for the repair or the remodel.

FAQs

A wide opening with a new beam where the kitchen wall was removed

How long does Schluter waterproofing last in a Boulder City kitchen?

Treated properly, a Kerdi or Ditra assembly lasts 20 to 30 years or more, and many manufacturers publish that expectation. In Boulder City, the dry heat and large day-to-night temperature swings matter most. A membrane installed correctly over a clean, primed substrate holds up well. One installed over dust or moisture fails early. For an exact repair number, call (844) 797-9259; estimates are free.

Can the Schluter part be repaired instead of replaced?

Often, yes. A failed corner band or a single lifted tile can be repaired without removing the whole assembly, as long as the substrate underneath is sound. If the thinset has gone soft or water has spread, we replace the affected section. We confirm which it is after removing one tile and checking the bond.

How long does the replacement take?

A targeted tile-and-membrane repair runs one to three days once we’ve confirmed the scope. A full kitchen remodeling project with new Schluter waterproofing takes weeks, not days, and we schedule it around your kitchen use. Call (844) 797-9259 for a written timeline with your price.

How do you source the Schluter part?

We order genuine Schluter parts to the model and dimension we verify from your label, and we never stock parts on a truck. That means the part you get is the one your assembly calls for, not a lookalike. If an accessory has a sound aftermarket match, we’ll tell you and price both.

Every Bradford Remodeling Boulder City project closes squared away: clean site, documented scope, and your signed written guarantee in hand. Not ready to price yet? That’s fine. When you are, call (844) 797-9259 for a free estimate and a written price before any work starts.

Written by the team at Bradford Remodeling Boulder City, serving Boulder City and nearby areas.

Ideas for every room in the house

Built-ins, window seats, family rooms and staircases: the changes that make a whole house work better.

Read our remodeling guides
A powder room with botanical wallpaper and a stone sinkA remodeled laundry and mudroom with a bench, cubbies and painted cabinetsA built-in window seat in a bay windowA dining nook with a built-in banquetteA home office with a built-in desk and shelvesA wood double vanity with two mirrors after a bathroom remodel

Explore more remodels

Every project below starts the same way: a free on-site visit and a written price.

Getting started with Bradford in Boulder City

Every project starts with a conversation and a written price. Here is how to take the first step.

A project lead measuring a kitchen with the homeowner during a free estimate

Free on-site estimate

A project lead walks the job with you, measures it and hands you a written, line-item price. No obligation.

Book an estimate
A remodeling crew arriving at a home with lumber and tools

Your Boulder City team

A local vetted partner works across Boulder City and the towns around it, to the same written standard as every Bradford job.

Areas we serve
A worker laying floor protection and a dust barrier before work starts

Read our written promise

What we promise on every job, written down, with the terms spelled out before any work starts.

Our promise
Need Construction help nationwide? Licensed & insured · free written estimates
Call (844) 797-9259
Local Service Coverage

Request a Free Estimate in Boulder City

Tell us what you need - Bradford Remodeling Boulder City responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Text Us
Call Now - 24/7 Dispatch